Will a Single Carbon Tank Clear Chloramines and 28.4 ppt PFOS Across My Lighthouse Point Home?

The short answer: In Lighthouse Point (Broward County District 2), no single filter optimally resolves both utility chloramines and micro-contaminants like PFOS

By the WaterLux Editorial Team · Published 2026-10-15

Will a Single Carbon Tank Clear Chloramines and 28.4 ppt PFOS Across My Lighthouse Point Home?

Last updated: October 2026 · Reviewed by WaterLux Water Treatment specialists

The short answer: In Lighthouse Point (Broward County District 2), no single filter optimally resolves both utility chloramines and micro-contaminants like PFOS at 28.4 ppt. A whole-house catalytic carbon system is necessary at the point-of-entry to reduce chloramine bleach taste and reduce broad organics across all fixtures, while a kitchen point-of-use reverse osmosis membrane is required to filter smaller PFAS molecules down past future 4 ppt federal limits.

Lighthouse Point's water carries 9 PFAS compounds with PFOS at 28.4 ppt—does one filter cover them all?

Homeowners reviewing the Lighthouse Point water record often notice two distinct issues: a sharp disinfectant taste at the shower and tap, and recent environmental sampling reporting synthetic chemicals in the supply. Broward County Water and Wastewater Services (District 2) (PWSID FL4060163, serving 54,622 residents) uses softening, filtration, and chloramine disinfection to process local raw groundwater. While the public system maintains 0 health-based violations over the last 5 years, disinfectant practices and persistent compounds leave measurable traces at the tap.

According to U.S. EPA PFAS sampling conducted in 2025, finished drinking water leaving the treatment plant contained 9 distinct PFAS compounds. PFOS was measured at 28.4 ppt and PFOA at 11.5 ppt. Both levels exceed the EPA's enforceable Maximum Contaminant Level (MCL) of 4 ppt, which takes effect in 2029. Additionally, 2024 monitoring recorded total trihalomethanes (TTHM) at 33 ppb and haloacetic acids (HAA5) at 21.4 ppb, alongside 2025 lead levels of 3.1 ppb at the 90th percentile of tested home taps. Before utility processing, raw groundwater in Lighthouse Point carries a source hardness of 14.3 GPG (245 mg/L), classified as very hard by USGS historical well data.

A single point-of-entry carbon tank cannot completely resolve both problems simultaneously due to water flow rates and chemical contact time requirements. Addressing high chloramine volumes across every bathroom while lowering short-chain and long-chain PFAS molecules to baseline targets requires separating point-of-entry bulk filtration from point-of-use membrane extraction.

How does point-of-entry catalytic carbon target utility chloramines across all fixtures?

Chloramines are formed by combining chlorine with ammonia to create a stable disinfectant that persists through miles of distribution piping. Standard activated carbon acts slowly against chloramines, allowing the chemical compound to pass through higher flow rates unchanged. Treating chloramines at the main service line requires specialized catalytic carbon—a surface-modified media designed to promote rapid electron transfer, breaking the bond between chlorine and ammonia.

When installed where main water enters the home, a dedicated backwashing catalytic carbon filter processes all incoming water for showers, laundry, and sinks. Sized according to peak household flow rate (measured in gallons per minute), these systems maintain the necessary empty bed contact time (EBCT) to reduce chloramine disinfectant taste and reduce volatile organic compounds across all home fixtures. While catalytic carbon also lowers broad organic loads, high flow rates during simultaneous appliance use prevent it from achieving maximum physical reduction on small-molecule PFAS compounds like PFOS and PFOA.

Why is point-of-use reverse osmosis required for maximum PFAS compound rejection?

Per- and polyfluoroalkyl substances (PFAS) are man-made fluorinated chemicals resistant to heat, water, and oil. Molecules like PFOS (measured at 28.4 ppt in local plant sampling) and PFOA (11.5 ppt) possess strong carbon-fluorine bonds that move quickly through standard filtration beds under household tap pressure. To pull these compounds down past the EPA's 4 ppt target limit, a physical separation barrier is needed.

Installing an under-sink reverse osmosis system at the primary drinking tap pairs specialized carbon pre-filtration with a semi-permeable membrane. The system operates at lower, controlled flow rates (measured in gallons per day), forcing water molecules through membrane pores as small as 0.0001 microns. This tight physical matrix rejects small fluorinated molecules, providing high-rejection performance for PFOS, PFOA, and the 7 other PFAS compounds identified in local sampling. Combining a kitchen membrane unit with a main-line carbon tank balances high-volume utility treatment across the house with high-efficiency filtration for consumption.

Comparing Whole-House Catalytic Carbon vs. Point-of-Use Reverse Osmosis

Treatment Comparison for Lighthouse Point Municipal Water
Performance Feature Whole-House Catalytic Carbon (POE) Point-of-Use Reverse Osmosis (POU)
Scope of Protection Treats entire home flow; removes chloramine bleach taste and lowers organics at every shower, sink, and appliance. Treats a single dedicated tap; isolates drinking and cooking water for maximum contaminant barrier.
Chloramine Disinfectant Removal High effectiveness via specialized catalytic carbon bed providing required contact time at entry. Limited to the kitchen tap water only; leaves bathrooms and showers unaddressed.
PFAS Compound Rejection (PFOS 28.4 ppt / PFOA 11.5 ppt) Reduces broad organic loads, but performance varies across short-chain PFAS molecules at high flow rates. Provides maximum physical membrane barrier rejection for short and long-chain PFAS at controlled drinking flow rates.
Physical Footprint & Installation Location Main water service entry point (garage, utility closet, or exterior slab). Under the kitchen sink with a dedicated drinking water faucet.
Maintenance & Media Service Periodic backwashing with catalytic carbon media replacement every few years depending on volume. Annual sediment/carbon cartridge changes plus periodic membrane replacement.

What equipment configuration resolves both problems for Broward County homes?

Homeowners seeking comprehensive coverage for both utility disinfectants and micro-contaminants find that pairing whole-house filtration with point-of-use membrane systems provides the necessary balance. A whole-house backwashing catalytic carbon filter (installed at the main shutoff) reduces chloramines, reduces TTHM (33 ppb) and HAA5 (21.4 ppb) levels, and protects bathroom fixtures. Meanwhile, a 5-stage under-sink reverse osmosis system delivers dedicated drinking water, addressing PFOS at 28.4 ppt, PFOA at 11.5 ppt, and lead traces (3.1 ppb).

Homeowners looking to explore system pricing can reference our published options, including essential whole-house filtration From $1,595, dedicated reverse osmosis systems From $1,295, or comprehensive whole-house catalytic carbon units From $1,595. Professional equipment setup is executed by a Licensed and insured installer to ensure systems are installed to manufacturer specifications.

Why WaterLux?

Frequently Asked Questions

Does a standard Big Blue carbon filter remove both chloramine taste and PFAS in Lighthouse Point?
No. Standard Big Blue cartridges contain standard granular activated carbon or block carbon, which lacks the contact time needed to break chemical chloramine bonds at whole-house flow rates. Furthermore, smaller cartridge footprints channel under pressure, allowing micro-contaminants like PFOS (measured at 28.4 ppt in local EPA sampling) to pass through. Comprehensive treatment requires a full-sized backwashing catalytic carbon tank at the entry line paired with a high-rejection reverse osmosis membrane at the tap. For questions on sizing, call 754-317-0104.
Why does Lighthouse Point municipal water have a strong bleach or chlorine taste if it is treated with chloramines?
Broward County Water and Wastewater Services (District 2) uses chloramine disinfection (combining chlorine and ammonia) to maintain residual disinfection across 54,622 service connections. Chloramines leave a distinct, persistent chemical odor and taste that does not dissipate in open pitchers like standard free chlorine. Removing this chemical compound from shower and tap water requires high-efficiency catalytic carbon media engineered specifically for chloramine breakdown.
Should I install a whole-house carbon tank or a sink-mount reverse osmosis system for PFAS protection in Broward County?
A complete treatment design uses both. Whole-house catalytic carbon lowers organic chemical loading and removes disinfectant taste at every tap, shower, and appliance across the home. However, addressing small-molecule compounds like PFOS (28.4 ppt) and PFOA (11.5 ppt) down past the EPA's upcoming 4 ppt limit requires the fine physical membrane barrier of an under-sink reverse osmosis unit operating at controlled drinking-water flow rates. Learn more by contacting our team at 754-317-0104.
How often do catalytic carbon media beds need replacement to maintain chloramine taste removal in South Florida?
In Broward County, catalytic carbon media beds operating under standard municipal water conditions typically require re-bedding every 3 to 5 years. High municipal chloramine levels and continuous household usage gradually exhaust the active catalytic reaction sites on the carbon surface. Routine annual inspection through professional water filtration maintenance ensures the media maintains optimal contact efficiency.
Does WaterLux offer in-home water evaluations in Lighthouse Point?
Yes, WaterLux provides detailed in-home water evaluations throughout Lighthouse Point, Broward County, Miami-Dade, and Palm Beach counties. A specialist visits your property to review main water entry lines, measure household flow rates, test current utility tap metrics, and recommend targeted equipment configurations designed to address local source hardness (14.3 GPG before treatment) and disinfectant levels.
How long has WaterLux been serving Broward County?
WaterLux has operated as a local, family-owned water treatment company in Pompano Beach for over 14 years. Serving Miami-Dade, Broward, and Palm Beach counties, WaterLux operates as an authorized Hague Quality Water dealer and Aquaphor Exclusive Distributor, delivering premium whole-house filtration and reverse osmosis installations fitted by a Licensed and insured installer to manufacturer specifications.

Worried About What's In Your Water?

(754) 317-0104

Talk to a WaterLux specialist — we will match the right testing approach

(754) 317-0104 Get your quote

https://waterlux.com/blog/lighthouse-point-will-a-single-carbon-tank-clear-chloramines-and-pfos-across-my